----------------------------------------------------- SUMMARY OF CHANGES IN RIVERWARE PATCH RELEASE 6.9.6 ----------------------------------------------------- Released October 11, 2016 ----------------------------------------------------- Batch Mode ------------------------------ Within Batch Mode and the RiverWare Command Language (RCL), the SetRunInfo command can be used to change the run range. A new argument !StartDate was added to this command. This argument can be used as an alternative to the !InitDate argument. Bugs ------------------------------ The following issues were addressed: • 5720: A crash could occur when a Diversion object's passthrough account was linked to a Reservoir's storage account. • 5755: For the Reservoir's Segmented 2 Layer Salt water quality method, a check was added to ensure there is a valid initial Bank Storage Concentration when Bank Storage is modeled. • 5774: On the Control Point, the Compute Aggregate Coefficients method was not correctly catching an error condition. When this method is selected, the Control Point must be part of a Computational Subbasin that will trigger the coefficient computation. • 5778: Under certain circumstances, the Geospatial view configuration became corrupted and was blank. This condition is now prevented. In addition, existing models should be fixed to not be blank. • 5783: On a Reach using the "No Local Inflow, Solve Outflow" method (in the Local Inflow and Solution Direction category), it was possible to specify or propagate an Outflow that was inconsistent with the lagged Inflow. Now, this circumstance will result in an error. • 5789: Within a run, RPL Set items could be enabled or disabled. This is now prevented. • 5797: An internal error dialog was hidden by the run aborted dialog, and the user could not close any dialogs. --- [end] ---